Skip to Content
PEX · ABS wheel speed sensor

412.384OE-grade wheel speed sensor for ABS, traction and stability systems.

Reads the tone ring at the wheel end and feeds wheel-speed data to the ABS control module. Built and validated to original-equipment signal and durability standards.

Replaces Bendix 801550 and 15 more numbers
16
Cross references
7
Makes
HD
Heavy duty
3 yr
Warranty*
Request a quote
PEX 412.384 ABS sensor
Fitment check

Does 412.384 replace your number?

Type the OE or aftermarket number from the old part or your parts list. Spaces, dots and dashes don't matter.

Start typing to check against 16 listed numbers.
Cross references

Numbers this part replaces.

Tap any number to copy it. Filter by make to see only the numbers for your fleet.

BENDIX1 NO.

FORD1 NO.

FREIGHTLINER2 NO.

MACK1 NO.

NAVISTAR8 NO.

STERLING2 NO.

VOLVO1 NO.

Specifications

Technical detail.

PEX reference412.384
DescriptionABS sensor
CategoryABS wheel speed sensor
ApplicationHeavy duty
Cross references16
Makes listed7
Warranty3 years / 100,000 miles*

*Typical for this product line; terms may vary by part, application and purchase agreement. Confirm coverage with our team before ordering.

Need more detail?

Dimensions, connector or resistance values

Send us the application or the number from the old part and our team will confirm the details before you order.

Ask our team
Know the signs

When it starts to fail.

ABS lamp on

A weak or missing signal from one wheel end is one of the most common reasons the ABS warning lamp stays lit.

Wheel speed fault codes

Codes for an erratic signal, open circuit or a speed mismatch between wheels usually point to the sensor, its cable or the tone ring.

Erratic ABS at low speed

ABS cycling during gentle stops, or trailer ABS that drops in and out, often traces back to sensor gap or signal loss.

Installation

Fit it right first time.

Install checklist
  1. Inspect the tone ring. A cracked, corroded or dirty ring causes the same faults as a failed sensor.
  2. Fit a new sensor clip and apply the specified lubricant to the clip and bore.
  3. Push the sensor in until it touches the tone ring. Wheel-bearing end play sets the final gap.
  4. Route the cable away from heat and moving parts, secure it, and seal the connector.
Quick test before you replace

Check coil resistance at the connector, then spin the wheel and look for a clean signal. If the sensor tests good, inspect the tone ring, cable and connector before replacing it.

Questions

Common questions.

Will 412.384 replace my Bendix 801550?

Yes. 801550 is listed as a cross reference for 412.384. Confirm fitment by OE number or chassis before ordering, or send us the number and we will confirm it.

What if the cable doesn’t reach?

PEX offers ABS extension cables in several lengths. Tell us your application and we will confirm which one matches.

How do I get pricing?

PEX sells through quotes, not online checkout. Send the part number and quantity and our team typically responds within 1–2 business days (Mon–Fri, 8–5 CST).

Can I order in volume for a fleet or distribution?

Yes. Fleets and distributors can request quotes for volume orders. For ongoing supply, see Stock PEX or contact us directly.

Quote, not checkout

Need 412.384 for your fleet?

Send the part number and quantity. Our team confirms fitment and comes back with pricing and lead time.

412.384 · ABS sensorRequest a quote
Copied