Skip to Content
Home/Quality & Testing
Quality & Testing

How we validate.

Aftermarket quality claims are easy to make and hard to check. This is what PEX actually does before a sensor is listed, sold, and installed on a vehicle — described plainly, so you can judge it against what other suppliers tell you.

Housing sealSignal outputResistanceConnector fit
The Process
01

Specification match

Every part is specified against the OE application it replaces — connector type, pin configuration, response curve, and mounting geometry. A sensor that reads correctly but does not fit, or fits but reports the wrong curve, is a failed part.

02

Incoming inspection

Shipments are checked against the specification on receipt: dimensions, connector and pin condition, housing and seal integrity, and labelling. Discrepancies are quarantined before anything reaches stock.

03

Functional screening

Sensors are screened for correct electrical behaviour — continuity and resistance, signal output, and, where the sensor communicates digitally, protocol response. This is where units that would throw a fault code on the vehicle are caught.

04

Documentation and traceability

Parts are recorded against their PEX reference and cross-reference data, so a part number can be traced back to what it replaces and what was verified.

Testing depth varies by sensor family. The pages below set out what applies to each type — ABS and NOx sensors, for example, are screened differently because they fail differently.
By Sensor Type

Testing standards by sensor family.

Evaluating PEX as a supplier?

Request coverage data, line-card information, and distribution terms. Tell us the platforms you support and we will come back with what we cover.